KB56600
Published: July 5, 2007
Revision: 3.0

ioControl / PAC Control ‘Move Numeric Table to I/O Unit’ command attempts to write to disabled I/O units


Applies To:

SNAP-PAC-S1
SNAP-PAC-R1
SNAP-PAC-R2
SNAP-UP1-ADS
SNAP-UP1-M64
SNAP-UP1-D64
SNAP-LCE

Versions Affected:

Problem was discovered in firmware version: R8.0a SNAP PAC, R7.1h Ultimate I/O firmware
Problem is fixed in version: R8.0b SNAP PAC firmware, R7.2 Ultimate I/O firmware

Resolved In Version:

Problem is fixed in version: R8.0b SNAP PAC firmware, R7.2 Ultimate I/O firmware


Symptoms:

If the PAC Control and ioControl Move Numeric Table To I/O Unit command is sent to an Ethernet-based I/O unit, the controller performs a write to the unit’s analog points, even if the unit is disabled. If the I/O unit is online, this may cause the unit’s analog output values may change unexpectedly. If the unit is not online, a -534 (maximum retries) error, and several -444 (send failure) errors are placed in the controller error queue.


Resolution:

Opto 22 has resolved this issue.


Questions?

Contact: Opto 22 Product Support.
Phone: 800-835-6786 or 951-695-3080
Email: support@opto22.com


DISCLAIMER

This Opto 22 Knowledge Base ('OptoKB') article is intended to provide general technical information on a particular subject or subjects and is not an exhaustive treatment of such subjects. Accordingly, the information in this OptoKB article is not intended to constitute application, design, software, or other professional engineering advice or services. Opto 22 may modify the OptoKB articles at any time. Before making any decision or taking any action which might affect your equipment, you should consult a qualified professional.

OPTO 22 DOES NOT WARRANT THE COMPLETENESS, TIMELINESS, OR ACCURACY OF THE DATA CONTAINED IN THIS OPTOKB ARTICLE AND MAY MAKE CHANGES THERETO AT ANY TIME AT ITS SOLE DISCRETION WITHOUT NOTICE. FURTHER, ALL INFORMATION CONVEYED HEREBY IS PROVIDED TO USERS 'AS IS.' IN NO EVENT SHALL OPTO 22 BE LIABLE FOR ANY DAMAGES OF ANY KIND INCLUDING DIRECT, INDIRECT INCIDENTAL, CONSEQUENTIAL, LOSS PROFIT, OR DAMAGE, EVEN IF OPTO 22 HAS BEEN ADVISED ON THE POSSIBILITY OF SUCH DAMAGES.

OPTO 22 DISCLAIMS ALL WARRANTIES WHETHER EXPRESSED OR IMPLIED WITH RESPECT TO THE INFORMATION (INCLUDING HARDWARE, SOFTWARE, AND/OR FIRMWARE) PROVIDED HEREBY, INCLUDING THE IMPLIED WARRANTIES OF FITNESS FOR A PARTICULAR PURPOSE, MERCHANTIBILITY, AND NON-INFRINGEMENT. Note that certain jurisdictions do not sanction the exclusion of implied warranties: thus, this disclaimer may not apply to you.

Copyright © 2024 Opto 22. All rights reserved.