KB48977
Published: April 24, 2006
Revision: 2.0

G4FUSE may cause intermittent G4 output module operation


Applies To:


Symptoms:

G4 output modules may operate intermittently.


Resolution:

The fuse insertion problem has been corrected.

The problem was found in some modules dated September 2005, or manufacture date code “JEXXXXXXCF”, as printed on the side of the module. The following instructions explain the Build Code.

  1. The first two characters in the Build Code is the year of manufacture. The last two characters in the Build Code is the week of manufacture.

  2. The year and week is decoded by the following chart:

  3. 1 = A 3 = C 5 = E 7 = G 9 = I
    2 = B 4 = D 6 = F 8 = H 0 = J

In the above example JE is 05 (2005) and CF is the 36th week of the year (September).

If you are experiencing intermittent behavior due to the described issue, contact Opto 22 Product Support for replacement fuses.


Questions?

Contact: Opto 22 Product Support.
Phone: 800-835-6786 or 951-695-3080
Email: support@opto22.com


DISCLAIMER

This Opto 22 Knowledge Base ('OptoKB') article is intended to provide general technical information on a particular subject or subjects and is not an exhaustive treatment of such subjects. Accordingly, the information in this OptoKB article is not intended to constitute application, design, software, or other professional engineering advice or services. Opto 22 may modify the OptoKB articles at any time. Before making any decision or taking any action which might affect your equipment, you should consult a qualified professional.

OPTO 22 DOES NOT WARRANT THE COMPLETENESS, TIMELINESS, OR ACCURACY OF THE DATA CONTAINED IN THIS OPTOKB ARTICLE AND MAY MAKE CHANGES THERETO AT ANY TIME AT ITS SOLE DISCRETION WITHOUT NOTICE. FURTHER, ALL INFORMATION CONVEYED HEREBY IS PROVIDED TO USERS 'AS IS.' IN NO EVENT SHALL OPTO 22 BE LIABLE FOR ANY DAMAGES OF ANY KIND INCLUDING DIRECT, INDIRECT INCIDENTAL, CONSEQUENTIAL, LOSS PROFIT, OR DAMAGE, EVEN IF OPTO 22 HAS BEEN ADVISED ON THE POSSIBILITY OF SUCH DAMAGES.

OPTO 22 DISCLAIMS ALL WARRANTIES WHETHER EXPRESSED OR IMPLIED WITH RESPECT TO THE INFORMATION (INCLUDING HARDWARE, SOFTWARE, AND/OR FIRMWARE) PROVIDED HEREBY, INCLUDING THE IMPLIED WARRANTIES OF FITNESS FOR A PARTICULAR PURPOSE, MERCHANTIBILITY, AND NON-INFRINGEMENT. Note that certain jurisdictions do not sanction the exclusion of implied warranties: thus, this disclaimer may not apply to you.

Copyright © 2024 Opto 22. All rights reserved.