KB81375
Published: January 17, 2012
Revision: 2.0

Chart appears to hang if 'Open Outgoing Communication' is sent to a disconnected device


Applies To:

SNAP-PAC-S1
SNAP-PAC-S2
SNAP-PAC-S1-W
SNAP-PAC-S2-W
SNAP-PAC-R1
SNAP-PAC-R2
SNAP-PAC-R1-W
SNAP-PAC-R2-W

Versions Affected:

Problem was discovered in version: R9.1b
Problem is fixed in version: R9.1d

Resolved In Version:

Problem is fixed in version: R9.1d


Symptoms:

Typically, if the Open Outgoing Communication command is sent from a PAC Control strategy to a device that is not connected and powered up, an error -412 is posted to the controller message queue. Beginning in version R9.1b, it could take up to 75 seconds for the command to fail and post the -412 error message. This long response time causes the chart to wait and do nothing until the 75 seconds has expired.


Questions?

Contact: Opto 22 Product Support.
Phone: 800-835-6786 or 951-695-3080
Email: support@opto22.com


DISCLAIMER

This Opto 22 Knowledge Base ('OptoKB') article is intended to provide general technical information on a particular subject or subjects and is not an exhaustive treatment of such subjects. Accordingly, the information in this OptoKB article is not intended to constitute application, design, software, or other professional engineering advice or services. Opto 22 may modify the OptoKB articles at any time. Before making any decision or taking any action which might affect your equipment, you should consult a qualified professional.

OPTO 22 DOES NOT WARRANT THE COMPLETENESS, TIMELINESS, OR ACCURACY OF THE DATA CONTAINED IN THIS OPTOKB ARTICLE AND MAY MAKE CHANGES THERETO AT ANY TIME AT ITS SOLE DISCRETION WITHOUT NOTICE. FURTHER, ALL INFORMATION CONVEYED HEREBY IS PROVIDED TO USERS 'AS IS.' IN NO EVENT SHALL OPTO 22 BE LIABLE FOR ANY DAMAGES OF ANY KIND INCLUDING DIRECT, INDIRECT INCIDENTAL, CONSEQUENTIAL, LOSS PROFIT, OR DAMAGE, EVEN IF OPTO 22 HAS BEEN ADVISED ON THE POSSIBILITY OF SUCH DAMAGES.

OPTO 22 DISCLAIMS ALL WARRANTIES WHETHER EXPRESSED OR IMPLIED WITH RESPECT TO THE INFORMATION (INCLUDING HARDWARE, SOFTWARE, AND/OR FIRMWARE) PROVIDED HEREBY, INCLUDING THE IMPLIED WARRANTIES OF FITNESS FOR A PARTICULAR PURPOSE, MERCHANTIBILITY, AND NON-INFRINGEMENT. Note that certain jurisdictions do not sanction the exclusion of implied warranties: thus, this disclaimer may not apply to you.

Copyright © 2024 Opto 22. All rights reserved.