KB81311
Published: July 29, 2011
Revision: 1.0

'High Density Digital Input Module #' incorrectly displayed for Event in Configure Mode


Applies To:

PAC Manager

Versions Affected:

Problem was discovered in version: R9.0c
Problem is fixed in version: R9.1a

Resolved In Version:

Problem is fixed in version: R9.1a


Symptoms:

The wrong Value type is displayed for an Event if for a previously configured Event, the High Density Digital State was configured for the Use which data for trigger #1? parameter.

To reproduce the problem, open a Configurator file, .cfg (File > Open), right-mouse click an I/O unit, click Configure > Events > Digital Events - Expanded. For the Use which data for trigger #1? parameter, select High Density Digial State. The following is shown:

If a different event is now selected, the High Density Digital Input Module # event is incorrectly displayed, as well as the incorrect Value type (a point mask instead of an integer) as shown in the following image:


Questions?

Contact: Opto 22 Product Support.
Phone: 800-835-6786 or 951-695-3080
Email: support@opto22.com


DISCLAIMER

This Opto 22 Knowledge Base ('OptoKB') article is intended to provide general technical information on a particular subject or subjects and is not an exhaustive treatment of such subjects. Accordingly, the information in this OptoKB article is not intended to constitute application, design, software, or other professional engineering advice or services. Opto 22 may modify the OptoKB articles at any time. Before making any decision or taking any action which might affect your equipment, you should consult a qualified professional.

OPTO 22 DOES NOT WARRANT THE COMPLETENESS, TIMELINESS, OR ACCURACY OF THE DATA CONTAINED IN THIS OPTOKB ARTICLE AND MAY MAKE CHANGES THERETO AT ANY TIME AT ITS SOLE DISCRETION WITHOUT NOTICE. FURTHER, ALL INFORMATION CONVEYED HEREBY IS PROVIDED TO USERS 'AS IS.' IN NO EVENT SHALL OPTO 22 BE LIABLE FOR ANY DAMAGES OF ANY KIND INCLUDING DIRECT, INDIRECT INCIDENTAL, CONSEQUENTIAL, LOSS PROFIT, OR DAMAGE, EVEN IF OPTO 22 HAS BEEN ADVISED ON THE POSSIBILITY OF SUCH DAMAGES.

OPTO 22 DISCLAIMS ALL WARRANTIES WHETHER EXPRESSED OR IMPLIED WITH RESPECT TO THE INFORMATION (INCLUDING HARDWARE, SOFTWARE, AND/OR FIRMWARE) PROVIDED HEREBY, INCLUDING THE IMPLIED WARRANTIES OF FITNESS FOR A PARTICULAR PURPOSE, MERCHANTIBILITY, AND NON-INFRINGEMENT. Note that certain jurisdictions do not sanction the exclusion of implied warranties: thus, this disclaimer may not apply to you.

Copyright © 2024 Opto 22. All rights reserved.