KB80248
Published: May 20, 2008
Revision: 2.0

Some SNAP-PAC-S1/S2 controllers may reset on power-up


Applies To:

SNAP-PAC-S1
SNAP-PAC-S2

Versions Affected:

Problem occurs in versions: R7.0a through R8.1a, in control engines with a Hardware Revison date of August 28, 2007 or later
Problem is fixed in version: R8.2a SNAP PAC firmware

Resolved In Version:

Problem is fixed in version: R8.2a SNAP PAC firmware


Symptoms:

SNAP-PAC-S1 and SNAP-PAC-S2 control engines with a Hardware Revision date of August 28, 2007 or later using firmware versions R7.0a through R8.1a, may reset on power-up. If the controller resets, the STAT LED blinks green twice, briefly blinks orange, and then repeats this blinking sequence.


Workaround:

Contact Opto 22 Product Support to discuss your problem’s circumstances and to request a beta firmware update. Please be advised that beta updates have not been fully tested and may not be suitable for critical applications.

To download the firmware once you have received it from Product Support, use PAC Manager and the Tools→Install Firmware via FailSafe Bootloader Mode option.


Resolution:

Opto 22 has corrected this problem.


Questions?

Contact: Opto 22 Product Support.
Phone: 800-835-6786 or 951-695-3080
Email: support@opto22.com


DISCLAIMER

This Opto 22 Knowledge Base ('OptoKB') article is intended to provide general technical information on a particular subject or subjects and is not an exhaustive treatment of such subjects. Accordingly, the information in this OptoKB article is not intended to constitute application, design, software, or other professional engineering advice or services. Opto 22 may modify the OptoKB articles at any time. Before making any decision or taking any action which might affect your equipment, you should consult a qualified professional.

OPTO 22 DOES NOT WARRANT THE COMPLETENESS, TIMELINESS, OR ACCURACY OF THE DATA CONTAINED IN THIS OPTOKB ARTICLE AND MAY MAKE CHANGES THERETO AT ANY TIME AT ITS SOLE DISCRETION WITHOUT NOTICE. FURTHER, ALL INFORMATION CONVEYED HEREBY IS PROVIDED TO USERS 'AS IS.' IN NO EVENT SHALL OPTO 22 BE LIABLE FOR ANY DAMAGES OF ANY KIND INCLUDING DIRECT, INDIRECT INCIDENTAL, CONSEQUENTIAL, LOSS PROFIT, OR DAMAGE, EVEN IF OPTO 22 HAS BEEN ADVISED ON THE POSSIBILITY OF SUCH DAMAGES.

OPTO 22 DISCLAIMS ALL WARRANTIES WHETHER EXPRESSED OR IMPLIED WITH RESPECT TO THE INFORMATION (INCLUDING HARDWARE, SOFTWARE, AND/OR FIRMWARE) PROVIDED HEREBY, INCLUDING THE IMPLIED WARRANTIES OF FITNESS FOR A PARTICULAR PURPOSE, MERCHANTIBILITY, AND NON-INFRINGEMENT. Note that certain jurisdictions do not sanction the exclusion of implied warranties: thus, this disclaimer may not apply to you.

Copyright © 2024 Opto 22. All rights reserved.